Clarion compact disc - Manual (Page 8)

When this unit is turned on, starting and stop-
ping the engine of a car with its volume raised
to the maximum level may harm your hearing.
Be careful about adjusting the volume.
NOTE: Use this unit after starting the engine.
Turning on the power and adjusting
the volume
1) After turning the car’s ignition switch on and
starting the engine, press the FUNC button
to turn on the power to the unit.
* The current mode is shown in Display .
* This unit starts in the mode it was in when the
power was turned off last.
2) Press the FUNC button to select the oper-
ation mode.
Each time you press the FUNC button
,
the operation mode changes as follows:
* Press and hold the FUNC button for about
1 second to turn off the power.
3) Slide the Up/Down button to (up) or
(down) to adjust the
volume.
: Increases the volume.
: Decreases the volume.
* The volume level indicated is in the display in
a range from 0 (minimum) to 33 (maximum).
Note:
• In the CONFIGURATION or BALANCE display,
the volume cannot be adjusted.
11
12
Tape mode
Radio mode
CD changer mode
(When the CD changer is connected)
CD mode
12
12
27
12
ACC or engine
ON position
14
English
Owner
’s Guide
9. OPERATION
Basic Operations
CAUTION
Note: Be sure to read this chapter referring to the front diagrams of
chapter “2. CONTROLS” on page 5 (spread).
CAUTION
THIS PRODUCT IS NOT INTENDED FOR
VIEWING TELEVISION BROADCASTS OR
VIDEO TAPES OR FOR PLAYING VIDEO
GAMES. Such uses of this product may
distract the driver or interfere with the dri-
ver’s safe operation of the motor vehicle
and may violate state law. CLARION DIS-
CLAIMS ANY LIABILITY FOR ANY BODILY
INJURY, INCLUDING FATALITIES, OR
PROPERTY DAMAGE THAT MAY RESULT
FROM ANY SUCH UNINTENDED USES OR
FROM ANY IMPROPER USE OF THIS
PRODUCT.
WARNING