Operating the equalizer, 25 english, Selecting the equalizer pattern – Clarion compact disc User Manual
Page 19: Designing and storing equalizer patterns, Turning on and off the equalizer pattern
This unit has a built-in 7-band graphic equalizer
to adjust the sound level in each frequency
range. You can select one of the four preset pat-
terns (basic equalizer), or can set four patterns
by yourself and select one (user equalizer).
Note:
•
In the following operation, when the hand mark (
)
appears in the display, the previous mode is
recalled if no operation is made within 5 seconds.
Selecting the equalizer pattern
Note:
•
In EQ USER display, design equalizer pattern by
yourself and store them. For further detail, see the
next subsection “Designing and storing equalizer
patterns.”
1) Press the EQ button
.
2) Press the BND button
to select EQ USER
or EQ BASIC.
*
Each time you press the BND button
, dis-
play toggles between EQ BASIC and EQ
USER.
3) Select an equalizer pattern by pressing one
of buttons
to
.
Note:
•
Be sure to turn on the equalizer effect. Otherwise,
the equalizer effect is not available. For this oper-
ation, see the subsection “Turning on and off the
equalizer pattern.”
Designing and storing equalizer
patterns
1) Press the EQ button
.
2) Press the BND button
to select EQ USER
display.
*
Each time you press the BND button
, the
display toggles between EQ BASIC and EQ
USER.
3) Select an equalizer pattern to be stored
(USER1 to USER4) by pressing one of but-
tons to .
4) Press
(center) of the ENT button
to
select the equalizer setting mode.
5) Slide the Up/Down button
to
(left),
(right),
(up), or
(down) to set an
equalizer pattern.
6) After setting the frequency pattern, press
(center) of the ENT button
to store it.
Note:
•
The stored equalizer pattern can be selected in
the same procedure as described in the previous
subsection “Selecting the equalizer pattern.”
Turning on and off the equalizer
pattern
1) Press the ADJ button
to select the CON-
FIGURATION display.
2) Slide the Up/Down button
to
(down) or
(up) to move the cursor to “EQ.”
3) Each time you slide the Up/Down button
to (right),
“ON” and “OFF” toggles.
*
When “OFF” is set, the EQ indicator
goes
off.
4) Press the ADJ button
to return to the pre-
vious mode.
10
5
11
11
10
11
Increases the sound level.
Shifts the
frequency range
to the right.
Shifts the
frequency range
to the left.
Decreases the sound level.
11
11
19
16
13
13
15
19
16
13
13
15
25
English
Owner
’s Guide
Operating the Equalizer