18 english, Preset selection, Calling the station with the isr button – Clarion compact disc User Manual
Page 12: Area change, Changing area
4) When a desirable station is tuned in, press
the SHIFT button
to cancel PS/AS mode
and press the preset button to which the sta-
tion is to be stored.
*
The preset scanning is canceled and you can
listen to the station.
Preset selection
1) Press the BND button
to select a band.
2) Press one of the Preset buttons
to
to
select the stored station.
Note:
•
In PS/AS mode, do not perform the preset selec-
tion (excluding the preset scanning).
In PS/AS mode, when the Preset button
is
pressed, the auto storing starts and all the stored
stations are cleared.
ISR memory
If an AM or FM station is stored in the ISR but-
ton, it can be directly tuned in by pressing the
ISR button from any other mode.
1) Press the BND button
to select a band.
2) Press the Preset buttons
to
or the ENT
button
to tune in to a station you want to
store.
3) Press and hold the ISR button
for about 2
seconds.
When a beep sounds, the display turns to the
ISR (Instant Station Recall) display and the
frequency is stored.
4) Press the ISR button
to return to the pre-
vious mode.
Calling the station with the ISR button
1) In any mode, pressing the ISR button
allows you to tune in to the stored station.
*
When the ISR is functioning, the ISR display
appears.
*
The default ISR setting is 87.9 MHz.
2) To cancel the ISR function, press the ISR but-
ton
or FUNC button
. The ISR function
is canceled and the previous mode returns.
Area change
When you listen to the radio outside the U.S.,
use this function.
Switchable frequency setting
This car stereo is initially set to tune in frequen-
cy intervals of 10 kHz for AM and 200 kHz for
FM, the standard calibrations in the U.S. When
using the unit outside the U.S., use the following
procedure to switch the frequency range.
The table below lists the frequency specifica-
tions for the U.S. and other countries.
Changing area
Depending on whether you use the unit in the
U.S. or outside the U.S., switch the area as fol-
lows:
1) Press the ADJ button
to go to the CON-
FIGURATION display.
2) Slide the Up/Down button
to
(up) or
(down) and move the cursor to “AREA.”
3) Slide the Up/Down button
to
(right) to
switch the area (between in the U.S. and out-
side the U.S.).
4) Press the ADJ button
to return to the pre-
vious mode.
*
The new setting returns to the initial setting.
10
11
11
10
New Setting
(outside U.S.)
Initial Setting
(U.S. standard)
9 kHz
10 kHz
Frequency
spacing
531 to 1629 kHz
530 to 1710 kHz
Frequency
range
50 kHz
200 kHz
Frequency
spacing
87.5 to 108 MHz
87.9 to 107.9 MHz
Frequency
range
AM
FM
12
24
24
24
24
11
21
16
13
17
21
16
13
22
18
English
Owner
’s Guide