Dell PowerEdge R300 - Manual (Page 22)

20
Four-Post Rack Installation
Installing a System With Static Rails
To install the system on the rack, perform the following procedure:
1 From the front of the system, lift the chassis into position so that the chassis rail modules are aligned
with the mounting rails on the rack.
2 Push the chassis back into the mounting rails until the system stops (see Figure 1-10).
3 Secure both thumbscrews on the front panel of the chassis.
4 Install the optional front bezel (if applicable). See the procedures for installing the bezel in the
documentation provided with your system.
Figure 1-10. Installing a System With Static Rails
1 mounting rails (2) 2 chassis rail modules (2) 3 thumbscrews (2)
4 release latches (2)
1
3
4
2