Baumer BA IRxx.DxxL - Manual (Page 11)

en_BA_IRxx .DxxL.docx 11/12 Baumer Electric AG
10.11.2014 14:03/simg V1.0 ANW_81146130 Frauenfeld, Switzerland
4.5.4 Factory reset
This sets the sensor to the settings which the sensor has when it is leaves the factory. In the mounting
instructions which are delivered with each sensor it is defined how a sensor behaves after factory reset.
Teach procedure: factory reset
5 Safety instructions and maintenance
5.1 General safety instructions
Intended use
This product is a precision device and is used for object detection and the preparation and/or provision of
measuring values as electrical quantities for a subsequent system. Unless this product is specially labeled, it
may not be used for operation in potentially explosive environments.
Commissioning
Installation, mounting and adjustment of this product may be performed only by a qualified person.
Installation
For mounting, use only the mechanical mountings and mechanical mounting accessories intended for this
product. Unused outputs must not be wired. In cable versions with unused cores, these cores must be
insulated. Always comply with admissible cable bending radii. Prior to electrical connection of the product, the
system must be disconnected from the power supply. In areas where shielded cables are mandatory, they
must be used as protection against electromagnetic disturbances. If plug connections to shielded cables are
made by the customer, an EMC version of the connectors should be used, and the shield must be connected
to the connector housing across a large area.
5.2 Maintenance
Inductive sensors do not require any maintenance or cleaning.
Connect teach wire
with +V (6s). When
yellow LED starts
flashing with 4 Hz,
cut connection
Red LED
flashes
shortly
 Teach
finished