Baumer DFOx - Manual (Page 4)

Identification
Input 100%
Loop current at 100%
(e.g. 20 mA)
Input 0%
Loop current at 0%
(e.g. 4 mA)
Input
Damping 0 = off / 1…30 sec.
Liniarization
correction
Enable / Disable
Display 100%
Displayed value
at 100% input
Display 0%
Displayed value
at 0% input
Decimals Digits after point
Display output Units Pressure units
Temperature units
Electric units
Configuration
Other units
Abs./Rel.
Select Absolute/Relative
or none
High error High error limit
MENU
High error indication
High error backlight
Error/warning setup
High warning Same as for high error
Display setup
Low warning Same as for high error
(see page 3)
Low error Same as for high error
Diagnostics
Relay 1 mode AO / AC / NO / NC
Relay 1 set point Point at which relay sets
Relay 1 reset point Point at which relay resets
Relay setup
Relay 2 mode AO / AC / NO / NC
Relay 2 set point Point at which relay sets
Relay 2 reset point Point at which relay resets
This menu section is only accessible when the relays are activated
TAG No. / Serial No. / Date / Prod.date
Page 4 Design and specifications subject to change without notice
Installation Manual www.baumer.com
5850-036_EN/2012-04-02
This data sheet ma
y only be reproduced in full.
Programming