Baumer G1-G2-G0-GE-GB-GXxxx - Manual (Page 17)

Manual_DeviceNet_BIDE_EN.docx 17/18 Baumer IVO GmbH & Co. KG
22.11.12 Villingen-Schwenningen, Germany
Bus cover – hollow shaft G0 and GB
10.2.5 Terminal assignment
Pin Terminal Description Colour M12 connector
male female
Pin 1 DRAIN Shield connection none
Pin 2 UB Supply voltage 10...30 VDC red
Pin 3 GND Ground connection relating UB black
Pin 4 CAN_H CAN Bus Signal (dominant High) white
Pin 5 CAN_L CAN Bus Signal (dominant Low) blue
Terminals with the same significance are internally connected and identical in their functions. Max. load on
the internal terminal connections UB-UB and GND-GND is 1 A.
Carefully plug the bus cover onto the D-SUB plug of the basic encoder, then press only via the sealing
rubber, taking care not to tilt it. The bus cover must rest fully against the basic encoder.
Tighten both the fastening screws firmly in the same direction.
The encoder housing and braided shield of the connecting cable are only ideally connected if the bus cover is
resting fully on the basic encoder (positive locking).