beautypg.com

F) sealant bottle and hose replacement, Jump-starting procedures – Dodge 2014 Challenger_SRT - Owner Manual User Manual

Page 406

background image

(F) Sealant Bottle And Hose Replacement:

1. Uncoil the Sealant Hose (6) (clear in color).
2. Locate the round Sealant Bottle release button in the

recessed area under the sealant bottle.

3. Press the Sealant Bottle release button. The Sealant

Bottle (1) will pop up. Remove the bottle and dispose

of it accordingly.

4. Clean any remaining sealant from the TIREFIT hous-

ing.

5. Position the new Sealant Bottle (1) in the housing so

that the Sealant Hose (6) aligns with the hose slot in

the front of the housing. Press the bottle into the

housing. An audible click will be heard indicating the

bottle is locked into place.

6. Verify that the cap is installed on the fitting at the end

of the Sealant Hose (6) and return the hose to its

storage area (located on the bottom of the air pump).

7. Return the TIREFIT kit to its storage location in the

vehicle.

JUMP-STARTING PROCEDURES

If your vehicle has a discharged battery it can be jump-

started using a set of jumper cables and a battery in

another vehicle or by using a portable battery booster

pack. Jump-starting can be dangerous if done improperly

so please follow the procedures in this section carefully.
NOTE:

When using a portable battery booster pack

follow the manufacturer’s operating instructions and

precautions.

6

WHAT TO DO IN EMERGENCIES 405