beautypg.com

Dodge 2014 Challenger_SRT - Owner Manual User Manual

Page 378

background image

longer display, and a pressure value will display in place

of the dashes. A system fault can occur due to any of the

following:
1. Signal interference due to electronic devices or driving

next to facilities emitting the same radio frequencies as

the TPM sensors.

2. Installing aftermarket window tinting that contains

materials that may block radio wave signals.

3. Accumulation of snow or ice around the wheels or

wheel housings.

4. Using tire chains on the vehicle.
5. Using wheels/tires not equipped with TPM sensors.
The EVIC will also display a ЉSERVICE TPM SYSTEMЉ

message for a minimum of five seconds when a system

fault related to an incorrect sensor location fault is

detected. In this case, the ЉSERVICE TPM SYSTEMЉ

message is then followed with a graphic display with

pressure values still shown. This indicates that the pres-

sure values are still being received from the TPM sensors

but they may not be located in the correct vehicle

position. The system still needs to be serviced as long as

the ЉSERVICE TPM SYSTEMЉ message is displayed.
Vehicles with Compact Spare

1. The compact spare tire does not have a TPM sensor.

Therefore, the TPMS will not monitor the pressure in

the compact spare tire.

2. If you install the compact spare tire in place of a road

tire that has a pressure below the low-pressure warn-

ing limit, upon the next ignition switch cycle, the

“TPM Telltale Light” will remain ON and a chime will

sound. In addition, the graphic in the EVIC will still

display a flashing pressure value and the ЉInflate Tire

to XXЉ message.

5

STARTING AND OPERATING 377