beautypg.com

Reprogramming a single homelink® button, Canadian/gate operator programming – Dodge 2014 Challenger_SRT - Owner Manual User Manual

Page 192

background image

5. Press and hold the programmed HomeLink® button.

The EVIC will display “CHANNEL # TRANSMIT.” If

the garage door opener/device activates, program-

ming is complete.

To program the remaining two HomeLink® buttons,

repeat each step for each remaining button. DO NOT

erase the channels.
Reprogramming A Single HomeLink® Button
To reprogram a channel that has been previously trained,

follow these steps:
1. Cycle the ignition to the ON/RUN position.
2. Press and hold the desired HomeLink® button until

the indicator light begins to flash after 20 seconds. Do

not release the button.

3. Without releasing the button proceed with “Program-

ming A Non-Rolling Code” step 2 and follow all

remaining steps.

Canadian/Gate Operator Programming

For programming transmitters in Canada/United States

that require the transmitter signals to “time-out” after

several seconds of transmission.
Canadian radio frequency laws require transmitter sig-

nals to time-out (or quit) after several seconds of trans-

mission – which may not be long enough for HomeLink®

to pick up the signal during programming. Similar to this

Canadian law, some U.S. gate operators are designed to

time-out in the same manner.
It may be helpful to unplug the device during the cycling

process to prevent possible overheating of the garage

door or gate motor.
1. Turn the ignition switch to the ON/RUN position.
2. Place the hand - held transmitter 1 to 3 inches (3 to 8 cm)

away from the HomeLink® button you wish to pro-

gram.

3

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 191