beautypg.com

Before you begin programming homelink – Dodge 2014 Challenger_SRT - Owner Manual User Manual

Page 188

background image

NOTE:

HomeLink® is disabled when the Vehicle Secu-

rity Alarm is active.

Before You Begin Programming HomeLink®

Ensure your vehicle is parked outside of the garage

before you begin programming.

For efficient programming and accurate transmission of the

radio-frequency signal it is recommended that a new

battery be placed in the hand-held transmitter of the device

that is being programmed to the HomeLink® system.
Erase all channels before you begin programming. To

erase the channels place the ignition in the ON/RUN

position and press and hold the two outside HomeLink®

buttons (I and III) for up to 20 seconds. The Electronic

Vehicle Information Center (EVIC) will display “CLEAR-

ING CHANNELS.” Release the buttons when the EVIC

displays “CHANNELS CLEARED.”
NOTE:

• Erasing all channels should only be performed when

programming HomeLink® for the first time. Do not

erase channels when programming additional buttons.

• If you have any problems, or require assistance, please

call toll-free 1-800-355-3515 or, on the Internet at

www.HomeLink.com for information or assistance.

HomeLink® Buttons

3

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 187