Canon HDMI SX800 - Manual (Page 32)

32
Steps for Setting Up the Projector and Projecting an Image
Performing the Auto Setup ( P50 )
Connecting the Projector to Equipment ( P36 , P37 )
Turning on the Power ( P47 )
Selecting an Input Signal ( P52 )
Adjusting the Image ( P54 )
Do the following adjustments.
• Setting the Display Resolution of the Computer (
P54 )
• Adjusting misaligned computer images or flickering of
the screen using the Auto PC ( P55 )
• Adjusting the Image Size ( P56 )
• Adjusting the Focus ( P57 )
• Adjusting keystone Distortion ( P58 )
Making Fine Adjustments
• Selecting an Aspect Ratio of Projected Image (Screen
aspect) and a Screen Mode (Aspect) ( P60 , P63 )
• Selecting an Image Mode ( P65 )
Do you want to project an image
from a notebook computer?
Image projected properly?
Image projected properly?
No
No
For a notebook computer, turn on
the monitor output (
P49 ) and then
go to Auto Setup.
Projection is complete.
Yes
No
Yes
Projection is complete.
Yes
In SX800, manually adjust the
focus.