beautypg.com

Anti-scan feature, Unlocking and locking the doors, Displaying the factory-set code – FORD 2014 Explorer v.3 User Manual

Page 88: With integrated keyhead transmitters, Locks 87

background image

Anti-Scan Feature

The keypad will go into an anti-scan mode if you enter the wrong code
seven times (35 consecutive button presses). This mode disables the
keypad for one minute and the keypad lamp will flash.

The anti-scan feature will turn off after:
• one minute of keypad inactivity
• pressing the unlock button on the remote control
• switching the ignition on
• unlocking the vehicle using intelligent access.

Unlocking and Locking the Doors

To unlock the driver door: Enter the factory-set 5-digit code or your
personal code. You must press each number within five seconds of each
other. The interior lamps will illuminate. Note: All doors will unlock if
the two-stage unlocking feature is disabled. Refer to Locking and
Unlocking
earlier in this chapter.

To unlock all doors: Enter the factory-set code or your personal code,
then press 3

4 within five seconds.

To lock all doors: Press and hold 7

8 and 90 at the same time with

the driver door closed. You do not need to enter the keypad code first.

Displaying the Factory-Set Code

With Integrated Keyhead Transmitters

Note: You will need to have two programmed passive anti-theft keys for
this procedure.

To display the factory-set code in the information display:

1. Place the first programmed key into the ignition and switch on the
ignition.

2. Switch the ignition off and remove the first programmed key.

3. Place the second programmed key into the ignition.

The factory-set code will briefly appear in the message center.

Locks

87

2014 Explorer (exp)
Owners Guide gf, 3rd Printing, September 2013
USA
(fus)