Resetting the power liftgate, Securicode™ keyless entry keypad (if equipped), Securicode™ keyless entry keypad – FORD 2014 Explorer v.3 User Manual
Page 86: Locks 85
When opening: The system will stop and a tone will sound three times
when it detects an obstacle. Remove the obstacle to operate the liftgate.
Resetting the Power Liftgate
The liftgate may not operate properly and you may need to reset it if any
of these conditions occur:
• A low voltage or dead battery
• A disconnected battery
• You manually close the liftgate and leave it ajar (unlatched)
To reset the power liftgate:
1. Disconnect the battery for 20 seconds then, reconnect the battery.
2. Manually close and fully latch the liftgate.
3. Power open the liftgate by using the transmitter or the instrument
panel control button.
SECURICODE™ KEYLESS ENTRY KEYPAD (IF EQUIPPED)
The keypad, located near the driver window, is invisible until touched
and then it lights up so you can see and touch the appropriate buttons.
Note: If you enter your entry code too fast on the keypad, the unlock
function may not work. Enter your entry code again more slowly.
You can use the keypad to:
• lock or unlock the doors
• recall memory features
• enable or disable the autolock
and autounlock
• arm and disarm the anti-theft
alarm
You can operate the keypad with the factory-set 5-digit entry code.
This code is located on the owner’s wallet card in the glove box and is
available from an authorized dealer. You can also create up to three of
your own 5-digit personal entry codes.
Locks
85
2014 Explorer (exp)
Owners Guide gf, 3rd Printing, September 2013
USA (fus)