Brake fluid, Brake hydraulic systems – BMW 760i Sedan 2004 User Manual

Page 199

197

Antifreeze and anticorrosion agents are
flammable. Therefore, do not pour over hot
engine parts, as otherwise they could catch
fire and cause burns.
Always observe the instructions for use
provided on the containers.

Always observe all applicable rules
and regulations for environmental

protection when disposing of used anti-
freeze and anticorrosion agents.

Checking coolant level

Correct coolant level with the engine cold –
approx. +68 7/206:

Turn the cap of the expansion tank
counterclockwise to allow any accumu-
lated pressure to escape, then continue
turning to open

The coolant level is correct when the
coolant extends to between the MIN
and MAX marks on the filler neck, refer
to the diagram adjacent to the filler
neck

If the coolant is low, slowly add coolant
up to the specified level – do not overfill.

Brake fluid

The symbol lights up and a mes-
sage appears in the Check Control:
The brake fluid in the reservoir has

fallen to below the minimum level.

The brake fluid reservoir is located under
the microfilter housing trim panel on the
driver's side of the vehicle. To have brake
fluid added to the system, or to have the

source of any brake fluid loss traced and
rectified, please contact your BMW center,
which can also supply the factory-
approved – DOT 4 – brake fluids.

Brake fluid is hygroscopic: it absorbs
moisture from the atmosphere over

the course of time.
To ensure that the brake system continues
to provide safe and reliable performance,
remember to have the brake fluid changed
every two years at the latest, refer to
page

and to the Service and Warranty

Information Booklet for US models or the
Warranty and Service Guide Booklet for
Canadian models.
Brake fluid is toxic and also damages vehi-
cle paintwork. Always store these agents in
tightly-closed original containers kept well
away from the reach of children.
Do not spill the fluid and do not refill the
brake fluid reservoir to beyond the MAX
mark. Should it come into contact with hot
engine components, the brake fluid could
ignite and cause personal injury in the form
of burns.

Always observe all applicable envi-
ronmental rules and regulations when

disposing of used brake fluid.

Warning lamp for Canadian models.

Brake hydraulic systems

A low brake-fluid level combined with
longer-than-usual pedal travel could be
a sign that one of the brake system's
hydraulic circuits has failed.

Proceed to the nearest BMW center.
Remember that pedal travel may be

increased, and there may also be a sub-
stantial increase in the amount of pedal
pressure required to brake the vehicle.
Please adapt your driving style accord-
ingly.