Telephoning with the car phone, Commissioning the bmwportable phone, Using the phone in your vehicle – BMW 760i Sedan 2004 User Manual

Page 180: Commissioning the bmw portable phone

Using the phone in your vehicle

178

Under certain conditions, an emergency
call is started automatically immediately
after a severe accident. The automatic
emergency call is not affected by the emer-
gency call button being pressed.

Telephoning with the car
phone*

Currently not available

If the BMW portable phone is not in the
cradle, you can telephone using the car
phone via the hands-free unit.
The telephone that can be used to set up
a connection is shown in the upper status
line on the Control Display.

The car phone must be enabled prior
to initial use. In this case, please con-

sult your BMW center.

Calls can be set up or accepted using the
following equipment:

Control Center, page

175

Voice command system, page

not for incoming calls

Buttons on the steering wheel, page

Telephone keypad, folding, page

176

Commissioning the
BMW portable phone

Precondition for portable phones with SIM
card:

You might have to enter a Personal
Identification Number, PIN

Release all keypad guards, refer to
separate Owner's Manual.

Fold back the cradle slightly

Insert the portable phone.

Before starting off place the BMW
portable phone in the cradle. You can

then operate the portable phone using the
button on the steering wheel, the Control
Center, the telephone keypad or the voice
command system, but not if you are in the
middle of a call using the car phone.
If you are in the middle of a call using the
BMW portable phone, the connection will
be cut off as soon as you take it from the
cradle.

Switching your BMW portable phone
on and off

You can switch your BMW portable
phone on and off by maintaining

extended pressure on the telephone key-
pad.

For portable phones with a SIM card, you
might have to enter the PIN after switching
on.

Entering lock code

If, after switching on the BMW portable
phone, you are requested by a message
from the Control Display to enter the lock
code:

Enter the lock code, e.g. 1234

Press the button

{

Telephone on}.