Practical interior accessories, Integrated universal remote control – BMW 760i Sedan 2004 User Manual

Page 113

111

Practical interior accessories

Integrated universal remote
control*

The concept

The integrated universal remote control
can replace as many as three hand-held
transmitters for various remote-controlled
accessories, such as door openers and
house alarm systems. The integrated uni-
versal remote control registers and stores
signals from the original hand-held trans-
mitters.

The signal of an original hand-held trans-
mitter can be programmed on one of the
three memory buttons 1. Following that,
each of the devices can be actuated with
the appropriately-programmed memory
button 1. The indicator lamp 2 flashes to
confirm transmission of the signal.

If the vehicle is sold, the memory buttons 1
should be cleared as described on
page

112

To prevent possible damage or injury,
before programming or using the inte-

grated universal remote control, always
inspect the immediate area to make certain
that no people, animals or objects are
within the travel range of the device. Also,
comply with the safety precautions of the
original hand-held transmitter.

Checking the compatibility

If you see this symbol on the pack-
aging or in the manual supplied with
the original hand-held transmitter, it

is safe to assume that it is compatible with
the integrated universal remote control.

If you have additional questions,
please consult your BMW center or

call 1-800-355-3515.
You can also visit these websites:
www.bmwusa.com or
www.homelink.com.
HomeLink is a registered trademark owned
by Johnson Controls, Inc.

Programming

Memory buttons

Indicator lamp

Fixed-code hand-held transmitter

Switch on the ignition

When using for the first time: press both
outer buttons 1 for approx. 20 seconds,
maintaining pressure until the indicator
lamp 2 starts to flash. The three mem-
ory buttons 1 are cleared

Hold the original hand-held transmitter
at a distance of approx. 2 in/5 cm to
8 in/20 cm from the memory buttons 1

The required distance between
the hand-held transmitter and

memory buttons 1 depends on the rele-
vant system of the original hand-held
transmitter used.

Simultaneously press the transmit but-
ton on the original hand-held transmit-
ter and the desired memory button 1 of
the integrated universal remote control.
Initially, the indicator lamp 2 flashes
slowly. Release both buttons as soon
as the indicator lamp 2 flashes rapidly. If
the indicator lamp 2 does not flash rap-
idly after approx. 15 seconds, change
the distance

To program other original hand-held
transmitters, repeat steps 3 and 4.

The corresponding memory button 1 is
now programmed with the signal of the
original hand-held transmitter.