Dynalco UM-600 Universal Monitor - Manual (Page 9)

8
Programming Instructions
Important: The UM-600 universal monitor must first be programmed prior to operation.
When first powering up the unit, the display will first indicate the firmware version and then go
to the operational mode. It may also display a screen warning that the time & date need to be
entered. This will be explained below.
To configure the UM-600 Monitor, first go to the main programming screen by pressing the
Menu / Escape key:
The following menu icons will appear from left to right:
Run Signal
- defines run status input type (if any)
Channel - enables each channel type and alarm thresholds
Calibration
- defines zero & span values for DCV & mA inputs
Alarm Settings
- for setting high /low alarm thresholds
Alarm Logs
- allows the user to view alarm status
Communication - Log Reader / Modbus setup
Data Logging - allows configuration of up to (10) different logging events
System - allows display customization & current date / time input