Dynalco UM-600 Universal Monitor - Manual (Page 12)

11
” Data Logging”
The UM-600 can be configured to log any of the parameters being monitored, at user defined
time intervals. The values are saved to an internal flash memory with sufficient memory to
hold up to 500,000 data values with date / time stamps. These values can be downloaded at
any time to a PC using Dynalco’s “Log Reader” software.
The logging of any parameter is configured as an event. The UM-600 will allow up to (10)
individual events to be defined.
Example # 1:
To configure data logging of an input value every 5 minutes:
Using the arrows on the keypad, select the “Data Logging” icon.
Next, select “Setup Log Events” and press the
arrow.
The next screen will display a list of (10) events that can be configured. If this is the first event
to be programmed, select “Event 1” and press the
arrow.
Next select “Enable” and press the
arrow.
The next screen allows you to define an “On” condition. In most cases this will not be needed
since the “On” condition is normally defined by an “engine run” signal. See above (page 9) for
the procedure for configuring the “run” signal. In this example, select “No” and press the
arrow.
The next screen named “Input To Log” allows the user to select which parameter to log.
Using the up / down arrows, select the input channel that is to be logged. Press
arrow.
The next screen named “Log Frequency” allows the configuration of how often (in minutes)
the value is to be logged. Press enter and edit for 5 minutes. Selecting escape
will return
to the “Log Frequency” screen. Press the arrow and then select “Yes” to save the
changes. Pressing the escape key two times will escape to the normal monitoring mode.