Dogtra 300M Series - Manual (Page 14)

Battery Charging Procedure
1. Attach the charging cables to both the
transmitter and receiver(s), as shown on page
2. Plug the charger into a 120-volt wall outlet or,
if using the accessory field charger, plug into a
cigarette lighter. (Use a 230-volt European
charger for Europe.) When properly plugged
in, all indicator lights should glow red.
The receiver automatically turns off when you
insert the charging cable into the battery-
charging receptacle on the receiver.
3. After charging, cover the battery charging
receptacles with the rubber plugs on the
transmitter and receiver.
4. The battery is fully charged with a 10-hour
charge. The lights will stay red during the
charging process. They DO NOT turn green
when fully charged. Charging the batteries for
more than 10 hours at one time will not extend
the battery life.
25
CHARGING THE BATTERIES
The indicator light on the transmitter or
receiver will not ACTIVATE.
The transmitter or receiver does not stay on
when one of the stimulation or pager buttons
is pushed.
24.
uses Ni-MH (Nickel-
Metal-Hydride) batteries.
1. Charge the unit before using the unit for
the first time.
2. Do not charge the batteries near any
flammable substances.
3. Fully charge the batteries for 10 hours if the
unit is to be stored without use for a period
of 3 months or more.
Recharge the unit if :
The LED indicator light on the
collar/receiver is emitting a red color.
CHARGING THE BATTERIES
24
CHARGING THE BATTERIES