Dogtra 300M Series - Manual (Page 13)

22
FITTING THE COLLAR ON THE DOG
FITTING THE COLLAR
ON THE DOG
PROPER FIT
The collar should be fitted so that the
surgical stainless steel contact points press
firmly against the dog’s skin. You should be
able to fit a finger in between the contact
point and your dog’s skin. The best location
is either side of the dog’s windpipe.
23
FITTING THE COLLAR ON THE DOG
IMPROPER FIT
A loose fit can allow the collar to move
around on the dog’s neck. When this happens,
the contact points may rub the skin and cause
irritation. If the collar is too loose, electrical
contact will be inconsistent and your corrections
will be inconsistent also.
Dogtra uses surgical stainless steel contact
points and Anti-microbial plastic to protect the
dog’s skin.
ATTENTION!
Leaving the collar/receiver in the same
location on the dog’s neck, for an extended
period of time can cause skin irritation. If the dog
is to wear the e-collar for long periods,
occasionally reposition the collar so that the
contact points are moved to a different location
on the dog’s neck. Make sure you check for skin
irritation, each time you use the unit.