Dogtra 300M Series - Manual (Page 11)

18
DESCRIPTION OF COLLAR / RECEIVER PARTS
Receiver Battery Charging Receptacle &
Rubber Plug
On the inside of the collar receiver, next to
the collar strap, is a battery charging receptacle
with a rubber plug. (See Battery Charging
Procedure on page 25)
If the dog was in salt-water, be sure to
rinse the receiver and charging port with
clean water.
Internal Antenna
All Dogtra E-collars have non-exposed
antennas that are located inside the collar/
receiver.
19
BATTERY CHARGER
The battery charger and charging cables
allow you to charge both the transmitter and
receiver at the same time. The battery charger is
designed for a 120-volt wall outlet. (European
230-volt AC chargers and 12-volt car chargers
are also available.)
To use the battery charger for the two-dog
unit, combine both sets of battery charging
(splitter) cables as shown. This enables you to
charge the transmitter and both receivers at the
same time.
BATTERY CHARGER
Charging Cable
120 volt
Charger
Wall Outlet
Two-dog unit only