Yealink SIP-T46G - Manual (Page 131)

Advanced Phone Features
121
When the monitored line receives an incoming call, the followings occur on the phone:

The phone plays a warning tone (if enabled).

The BLF key LED flashes red.

The caller ID appears on the LCD screen (if enabled).
In the following figure, the LCD screen shows an incoming call from 3606 on the
monitored line.
Note
When there is an active call on the IP phone, you can transfer the active call to the
monitored phone number directly by pressing the BLF key. The phone transfers the
active call differently depending on the transfer mode via DSS key. For more
information on the transfer mode on DSS key, refer to transfer in
DSS Keys section on
page 60 .
You can record calls by pressing a record key on the phone. The SIP-T46G IP phone
supports record and URL record.
Two ways of call recording:

Record: The phone sends SIP INFO message containing a specific header “Record:
on/off” to trigger a recording.

URL Record: The phone sends HTTP URL request to trigger a recording. Contact your
system administrator for the predefined URL.
Note Call record is not available on all servers. Contact your system administrator for more
information.
If your phone is locked and the type of the keypad lock is configured as Function Keys or
All Keys, you cannot use the Pickup, Dial, NewCall and Cancel soft keys until unlocked.