Bio-Rad ProteinChip Data Manager Software - Manual (Page 24)

Basic Maintenance Page 19
2. Wait for the System Active light on the lower right side of the reader to go
out, then turn off the reader power.
3. Remove the front cover from the reader. You will need to remove the two
screws at the top rear corners of the front cover and carefully disconnect
the “stack full” sensor cable.
4. Completely loosen the captive screws on either side of the rear cassette guide
(Fig. 16).
Fig. 16: The rear cassette guide, installed.
5. Remove the rear cassette guide from the autoloader back plate (Fig. 17).
Fig. 17: The rear cassette guide, removed.
6. Remove the two thumbscrews on either side of the pawl drive front
plate (Fig. 18).
Captive screw
Rear cassette guide
Captive screw