Bio-Rad Peelable Foil Heat Seal - Manual (Page 5)

Only qualified laboratory personnel trained in the safe use of electrical equipment should operate this
instrument. Always handle all components of the system with care and with clean, dry hands.
WARNING! The use of this instrument in a manner contrary to the instructions provided, or for
purposes other than those for which it is intended, may impair the safety protections afforded
by the equipment. Additionally, changes or modifications to this instrument by anyone other
than Bio-Rad Laboratories or an authorized agent may cause its safety protection features to
malfunction. Bio-Rad Laboratories is not responsible for any injury or damage caused by such
use or modification of the instrument.
WARNING! Do not attempt to repair the PX1 PCR plate sealer or remove its outer case.
There are no user serviceable components or adjustments inside the instrument. Opening the
instrument voids all warranties. Contact Bio-Rad Laboratories if you feel your instrument needs
service or repair.
WARNING! Use only power cords, accessories, and consumables authorized by Bio-Rad
Laboratories for use with this instrument. The use of nonapproved power cords, accessories, or
consumables may void the instrument warranty and can create a hazardous situation. Contact
Bio-Rad Laboratories for information on authorized power cords, accessories, consumables,
and their replacement.
WARNING! The surfaces inside the instrument drawer are extremely hot when the instrument is
operating and will stay hot for up to one hour after the instrument is turned off. Do not put your
hand or other body parts inside the unit while it is hot. Do not put any unauthorized objects in
the instrument drawer.
WARNING! Know your materials. The PX1 PCR Plate Sealer uses heat and pressure to seal the
plate and sealing film together. Some sample materials may be inappropriate for a heat sealing
process. For example, materials that are highly volatile or have low flash points may be at risk of
exploding or igniting during the sealing process.
WARNING! Risk of splashing. Always wear appropriate protection against splashing. The
PX1 PCR Plate Sealer uses heat to fuse the plate and sealing film together. Expansion of air and
materials sealed in the sample plate could cause the seal or sealing film to rupture, dispersing
the sample material in and around the instrument. This is especially true if the plate is jammed,
stuck, or left in the sealing bay for an extended time.
WARNING! The plate, sealing film, plate support block, and sealing frame may be hot after
a sealing cycle or if left in the instrument for an extended period of time. Allow the plate and
accessories to cool before handling.
WARNING! The display panel is made of glass and contains a liquid crystal substance. If the
display is damaged, the glass can break into shards and the liquid crystal substance may leak
out. The glass shards are sharp and can cut skin or other soft materials. The liquid crystal
substance is toxic. Do not allow glass shards or liquid crystal substance to get in your mouth or
eyes. If the substance comes in contact with your skin or clothes, wash it off thoroughly using
soap and water. Contact Bio-Rad Laboratories for further instructions and to arrange to have
your instrument repaired.
Regulatory Compliance
This instrument has been tested and found to be in compliance with all applicable requirements of the
following safety standards:
n
IEC 61010-1 Safety requirements for electrical equipment for measurement, control, and laboratory
use — Part 1: General requirements
n
IEC 61010-2-010 Safety requirements for electrical equipment for measurement, control, and laboratory
use — Part 2-010: Particular requirements for laboratory equipment for the heating of material
n
CAN/CSA-C22.2 NO. 61010-1-04 Safety Requirements for Electrical Equipment for Measurement,
Control, and Laboratory Use — Part 1: General Requirements
n
CAN/CSA-C22.2 NO. 61010-2-010-04 Safety Requirements for Electrical Equipment for
Measurement, Control, and Laboratory Use — Part 2-010: Particular Requirements for Laboratory
Equipment for the Heating of Materials
n
EN 61010-1:2001 Safety requirements for electrical equipment for measurement, control, and
laboratory use — Part 1: General requirements
iii