Great Plains 1520P Operator Manual - Manual (Page 79)

5/6/2010 118-732M
77 Veris Drive Operating Instructions
Figure 17. A New calibration number is suggested, along with the Old calibration number. Press Function key
to advance to window shown in Figure 18.
Figure 18. If you wish to keep the Old number, perhaps to re-run the calibration procedure, press the Down
arrow key. If you want to accept the New calibration number, press the Up arrow key.
Figure 19. Console window now displays the calibration number you have selected. This returns you back to
the beginning of Calibration mode as shown in Figure 20. To re-run the Calibration procedure, follow the
steps outlined above. It is suggested that you perform the calibration mode at least twice, and additional rep-
lications may be needed if Target and Actual amounts vary significantly.
Figure 20. Calibration Mode