Great Plains 1520P Operator Manual - Manual (Page 76)

1510P and 1520P
118-732M 5/6/2010
74
Press Function key until Calibration Number window appears. See Figure 2. Select drive calibration num-
ber based on row spacing and metering wheel, from chart on page 81. Use Up/Down arrow keys to set
Calibration number. Press Function key until the Calibration window appears as shown in Figure 3.
Figure 2. Example of volumetric calibration number. Enter new calibration number using Up/Down arrow keys. Press
Function key to advance to Calibration Mode.
Figure 3. Calibration window. Press up arrow key to enter calibration mode.
Figure 4. This is the first window that appears in Calibration mode. Press Function key to accept, or Up key to change
to metric settings.
Figure 5. Enter drill width here using Up/Down arrow keys. Press Function key to advance to next window.
Figure 6. Enter number of rows here using Up/Down arrow keys. Press Function key to advance to next window.