Great Plains NTA1300 Predelivery Manual - Manual (Page 7)

5 7/29/2004 NTA 1000 and NTA 1300 148-528Q
Great Plains Mfg., Inc.
Figure 4
Pivot Lock & Cylinder Stabilizer
Figure 5
Spring Leaf
Figure 6
Decal Placement on CPH Frame
Pivot Lock and Cylinder Stabilizer
Refer to Figure 4
1. Assemble the pivot lock (1) by sliding it completely
on the CPH frame as shown. Screw bolt (2) and jam
nut (3) into lock. Place the spring rod (4) through the
hole using set screw (5) to lock in place. Hook spring
(6) from pivot lock to spring rod. For adjustments re-
fer to the operator’s manual.
2. Install the cylinder stabilizers (7) by attaching the
boot end to the CPH frame using 5/8 x 3 bolts, flat
washers, 5/8 jam nuts (8) and lock nuts (9). Cylinder
are assembled to the “H” frame in the same manner.
Spring Leaf
Refer to Figure 5
3. Assemble roller stop pin, roller stops and roll pins (2)
to the ends of the Spring leaf (1). Assemble the
Spring leaf (1) to underside, against the plate of the
CPH frame with 1/2-13 x 1 13/16 x 3 3/4 u-bolt, 5/8
hex nut (3) for spacer and 1/2” lock washer and hex
nut.
4. Pull spring leaf ends back with 3/8-6 x 1 7/8 x 8 and
3/8 lock nut (4). Tension on the ends will be loosened
when CPH frame is assembled to the “H” frame.
Decal placement on CPH
Refer to Figure 6
5. Decal Reflector Amber
6. Decal 3 Color Strip
7. Decal Logo GP
8. ID Plate NTA 1000/NTA 1300
19421
19422
19455
Assembly