Great Plains DVN8324 Assembly Manual - Manual (Page 12)

8 8315-8324DVN Great Plains Manufacturing, Inc.
550-466Q-ENG 11/25/2013
Refer to Figure 6
Truss & Level Bar
8. Now the center frame trusses may be installed
using 5/8 x 1 1/2 hex bolts , secure with 5/8 lock
washers, 5/8 hex nuts and 3/4 x 2 hex bolts ,
secure with 3/4 lock washers and lock nuts.
9. Attach the h-bracket mounting plate with 3/4 x 2
hex bolts , secure with 3/4 lock washers and lock
nuts
10. Mount the bottom side of the h-bracket using the 1
x 2 29/64 pins , 1.5 x 1.0 x.075 machine washers
and 3/16 x 2 cotter pins.
11. Attach the level bar slide tube assembly into the
top side of the h-bracket , secure with 1 x 9 Gr. 8
hex bolt and 1 nylon lock nut.
12. Now slide the front of the level bar over the back
side of the level bar slide tube assembly , secure
with a 3/4 x 5 1/2 hex bolt and 3/4 nylock nut.
13. Attach rear of level bar to the torque tube with the
1 x 6 Gr. 8 special hex bolt and 1 nylon lock nut.
14. Mount the level bar cross tube to the level bar
side plates with 5/8 x 1 1/2 hex bolts , secure with
5/8 lock washers and 5/8 nuts.
15. Attach fold stop to the center frame trusses
with 5/8 x 1 1/2 hex bolts , secure with 5/8 lock
washers, 5/8 hex nuts.
• Insert the 1/2 x 4 1/2 pin w/keepers into tubes on
back of fold stop .
16. Now attach the cylinder rest pads to the center
frame trusses using 1/2 x 4 1/2 hex bolts , 1/2
lock washers and 1/2 nuts.
• Do not tighten rest pads until fold cylinders are
installed. See “Install 8315-8321 Wings” on page 12
or See “Install 8324 Wings” on page 14 for fold cylin-
der installation.
• Slide the cylinder rest pads until they are directly
under the fold cylinders.
17. All bolts may be tightened to specs, See “Torque
Values Chart” on page 37.
1
2
3
4
3
5
6
7
5
8
9
7
10
9
11
12 9
2
13 1
2
14
13
15
1 16
15