Great Plains 401-516A Installation Instructions User Manual
Page 2
401-514M
12/28/2007
Table of Contents
©
Copyright 2007. All rights Reserved.
Great Plains Manufacturing, Inc. provides this publication “as is” without warranty of any kind, either expressed or implied. While every precaution has been taken in the preparation
of this manual, Great Plains Manufacturing, Inc. assumes no responsibility for errors or omissions. Neither is any liability assumed for damages resulting from the use of the infor-
mation contained herein. Great Plains Manufacturing, Inc. reserves the right to revise and improve its products as it sees fit. This publication describes the state of this product at
the time of its publication, and may not reflect the product in the future.
Great Plains Manufacturing, Incorporated Trademarks
The following are trademarks of Great Plains Mfg., Inc.: Application Systems, Ausherman, Land Pride, Great Plains
All other brands and product names are trademarks or registered trademarks of their respective holders.
Printed in the United States of America.
YP Pressure Relief Kits
Great Plains Manufacturing, Inc.
Important Safety Information.................................... 1
Introduction ................................................................ 3
Description of Unit........................................................ 3
Document Family ......................................................... 3
Kits Covered by this Manual ........................................ 3
Hoppers Which May Be Updated............................. 3
Using This Manual ....................................................... 4
Owner Assistance ........................................................ 4
Installation Instructions ............................................ 5
Before You Start .......................................................... 5
Tools Required............................................................. 5
Prepare Hopper ........................................................... 5
Dismount Hopper ......................................................... 6
Remove Old Door Slide ............................................... 7
Install Bottom Weldment .............................................. 7
Install New Door Slide.................................................. 8
Assemble Upper Pipe Support..................................... 9
Attach 150 bu Angle Brackets.................................. 9
Install 82 bu Upper Components ............................... 10
Remove Support for Drilling ................................... 10
Mark Holes and Drill............................................... 10
Re-Install Strainer Support..................................... 11
Position Air Pipe..................................................... 11
Install Upper Pipe Support ..................................... 11
Install 150 bu Upper Components ............................. 12
Mark Holes for Drilling............................................ 12
Insert Pipe in Hopper ............................................. 13
Cap and Position Pipe ........................................... 13
Drill 150 bu Holes................................................... 13
Attach Upper 150 bu Support ................................ 14
Closeout..................................................................... 14
Appendix................................................................... 15
Torque Values............................................................ 15
Parts Lists .................................................................. 16
401-508A 82 bu Pressure Release Kit................... 16
401-508A Part Numbers .................................... 17
401-516A 150 bu Pressure Release Kit................. 18
401-516A Part Numbers .................................... 19
Existing Parts Affected ........................................... 19