Great Plains 3000 Operator Manual - Manual (Page 12)

10
Section 2 Operating Instructions
2700 and 3000 Three-Point Drill 118-365M-A 9/9/10
Great Plains Mfg., Inc.
Parking
Unhitching the drill while the box is loaded is not recom-
mended. Empty the box if possible. See Storage, “Mainte-
nance and Lubrication,” page 22 for additional
information on the long-term storage.
1. Park on a level, solid area.
2. Unpin and rotate the parking stands down into the
parking position. Replace pins as shown in Figure 2. If
the ground is soft, place a board under the parking
stand to increase ground contact area.
Figure 2
Parking Stand
3. Lower the drill to the ground.
4. Extend or retract the top link until the top 3-point pin is
free. Remove the pin.
5. Remove pins from the lower links.
16504