Great Plains 2525P Operator Manual - Manual (Page 87)

4/23/2010 118-915M
85 Veris Drive Operating Instructions
Refer to Figure 120
20. Console window now displays the calibration
number you have selected.
Refer to Figure 121
21. This returns you back to the beginning of Cal-
ibration mode as shown. To re-run the Cali-
bration procedure, follow the steps outlined
above. It is suggested that you perform the
calibration mode at least twice, and additional
replications may be needed if Target and Ac-
tual amounts vary significantly.
Figure 120
Figure 121
22732
22733