Great Plains DICKEY-john IntelliAg Planter-Drill Control L1 - Manual (Page 4)

OPERATOR’S MANUAL
IntelliAg PDC User Level 1 (GP)
11001-1508-200903
2 / INTRODUCTION
Figure 1
Work Screen
WORK SCREEN SYMBOLS
TARGET RATE
The Target Application Rate displays when Master Switch is off. The actual
applied rate appears during Work mode.
TARGET INCREASE/DECREASE % RATE
The Increase/Decrease rate is the percentage change being applied each
time the Material Increase/Decrease button is pressed during Work mode.
TARGET PRESET RATE
The Preset Rate is the applied rate that was entered at the Material
Configuration Setup screen and increases or decreases when the Material
Increase/Decrease button is pressed during Work mode.
IMPLEMENT LIFT SWITCH
When an implement lift switch is installed, the Main Work screen will identify
if the implement is in the up or down position. Using an implement lift switch
automatically turns the control channels on and off without turning the
master switch off. The Implement Lift Indicator must be in the Down position
and the Master Switch on for the control channels to operate. The
Implement Lift Switch box on the Ground Speed Configuration screen
must be enabled if an implement lift switch is used. Refer to the
Implement Lift Sensor instructions for installation location.
TASK CONTROLLER
The Task Controller icon appears on the Main Work screen when Task
Controller is active and controlling the application rate. Return to Task
Controller to stop a task.
3 2
4
1
+
RATE 1
Implement Lift
Indicator
(Down Position-GREEN)
Implement Lift
Indicator
(Up Position-RED)
T C T C
Setting Task
Controller Rate Logging Data
to SD card
T C
Setting Task
and Logging
Data