Great Plains DICKEY-john IntelliAg Planter-Drill Control L1 - Manual (Page 10)

OPERATOR’S MANUAL
IntelliAg PDC User Level 1 (GP)
11001-1508-200903
8 / SYSTEM OPERATION
USING THE VT BUTTONS
Virtual buttons located on the right side of the display are used to interact
with the IntelliAg system. Buttons will display differently on the screen when
in Operate and Nonoperate mode.
OPERATE MODE BUTTONS
MASTER SWITCH ON/OFF
The Master Switch On/Off button is available only when no physical master
switch is installed and assigned.
NEXT CHANNEL
The Next Channel button selects the next available channel to be active
and viewable. The active channel can be set to ON or OFF by selecting the
On/Off Channel button described below. The active channel is displayed in
reverse video display in a multiple channel configuration. The Target Rate
for a channel can be adjusted by using the Inc/Dec buttons described
below. The channel’s Inc/Dec buttons, as well as the ON/OFF buttons,
display the current material label. This key is visible only when multiple
channels have been configured.
INCREMENT
The Increment button increases the active channel’s target rate by the
amount specified in the Inc/Dec % or rate table setup for that material.
Increment can be pressed several times to increase the target rate by the
specified amount for every actuation until the maximum rate value or preset
value is reached. The active channel/material is displayed in the button text.
DECREMENT
The Decrement button decreases the active channel’s target rate by the
amount specified in the Inc/Dec % or rate table setup for that material.
Decrement can be pressed several times to reduce the target rate by the
specified amount for every actuation until the minimum rate value or preset
value is reached. The active channel/material is displayed in the button text.
INC/DEC RESET TO TARGET
The Inc/Dec Reset to Target button is used to return the active channel to
the original material target rate. This button is only available for channels
that are active and have preset disabled. The active channel displays in the
button text.