Great Plains TM700 Operator Manual - Manual (Page 23)

5/13/2003 500-052M
21 Preparation and Setup
Sprayers with Raven Automatic Monitors do not
have throttling valves. The pump is now at dead
head pressure. Adjust the hydraulic flow control
valve so that the spray pressure reaches 80 PSI
maximum on the nozzle pressure gauge. If so
equipped, reset the solenoid throttling valves as de-
scribed in the "Solenoid Throttling Valve" on
page 51.
Quad-Jet Agitators {Stainless Steel
Tanks Only}
Refer to Figure 10
The Quad-Jet agitator is the agitator in the stainless
steel tank. Each agitator has four holes that shoot jets of
water out at a high velocity. The agitator head is oriented
at 45 degrees, with reference to the tank ends, so that
the water jets are aimed at the corners of the tank. To en-
sure proper agitation, make sure that the agitator head is
always kept in the orientation as shown.
Figure 10
Tank Top View
Quad-Jet Agitator Head Orientation
12546