Great Plains TM700 Operator Manual - Manual (Page 20)

Tractor Mount Sprayer
500-052M 5/13/2003
18
Figure 8
Solenoid Valve Assembly
12537
Refer to Figure 8
13. Cut a 1" ID hose (12) that leads from the tee as-
sembly (8) to the bypass elbow. A 1" hose-barb
elbow will need to be in place at the bottom and
top of the tank as shown. An additional 1" elbow
(13) will need to be assembled so that the hose
can be connected without kinking. Also route this
hose through hose guard material between trac-
tor and tank. Tighten the #16 hose clamps on all
hose ends after assembling the hose.
14. Use cable ties (6) to secure the two hoses.