Great Plains TM700 Operator Manual - Manual (Page 19)

5/13/2003 500-052M
17 Preparation and Setup
Figure 7
Pressure Head Assembly
13229
Refer to Figure 7
11. Cut a 1" ID hose (10) that leads from the pump to
the solution Whirlfilter
®
hose barb. You will need
to place 1" elbow hose-barbs (11) as shown to
orient the hose up the side of the tank. Measure
out and cut a length of hose guard material (14)
along the area between the tractor and the tank,
and route hose from pump to Whirlfilter
® hose
barb through the hose guard material. Pump
suction and pressure line should also be routed
through the hose guard material where sharp
corners exist under the tractor transmission ar-
ea. Tighten the #16 hose clamps.
12. Use cable ties (6) to secure the hose under the
tractor.