Great Plains 2N-3010 Operator Manual - Manual (Page 53)

51
Appendix
12/27/05 2N-2410 and 2N-3010 Folding No-Till Drill 196-126M
Great Plains Mfg., Inc.
21790
Connect to tractor
battery.
Leave console loose
in the tractor cab.
Run this wire connector
out the cab and to the
back of the tractor.
At the front of the drill tongue, uncoil
the wire harness and connect the
plug to the plug coming from the
tractor cab.
Connect to the electric clutch
located on the left-hand side of
the frame.
Connect to the electric clutch
located on the right-hand side
of the frame.
Connect to the electric clutch switch
located on the left-hand gauge wheel
rockshaft.
At the rear of the tongue, uncoil the
wire harness and route appropriate
leads along the drill frame.
Electric Clutch Console and Wire Harness