Great Plains 2N-3010 Operator Manual - Manual (Page 22)

20
Section 3 Adjustments
2N-2410 and 2N-3010 Folding No-Till Drill 196-126M 12/27/05
Great Plains Mfg., Inc.
Electric Clutch Switch Adjustment
To adjust the height at which seed metering is turned off,
follow these steps.
Refer to Figure 3-2
1. Locate the height switch at left-hand gauge wheel.
2. Lower the implement until it is at a height where seed-
ing should start (usually just above the ground). Se-
curely support frame at this height with jack stands or
blocks.
3. Turn off the tractor and remove the key.
Refer to Figure 3-3
4. Loosen the cam clamp (1) on the gauge wheel rock-
shaft and turn until the switch roller (2) is just starting
to make contact with the ramp surface.
Refer to Figure 3-4
5. Raise the implement fully and check that the switch is
compressed as shown.
Figure 3-3
Figure 3-4
14550
Figure 3-2
15160
19711