Wheatheart Self-Propelled Auger Kit (Wheatheart R Series) - Manual (Page 29)

W HEATHEART - S ELF -P ROPELLED A UGER K IT 3. A SSEMBLY
W HEATHEART BH & R S ERIES 3.13. H OSE K IT A SSEMBLY
30761 R0 29
3.13. HOSE KIT ASSEMBLY
Refer to Figures 3.11 - 3.16.
1. Assemble hoses as illustrated.
2. Keep free of dirt while assembling.
3. Keep pressure and return sides aligned.
4. Tighten after being satisfied that the hoses are in the proper position.
5. Check
operation.
6. Secure hoses in place with the cable ties supplied
Important: Before disassembling the hoses, fully lower the auger and relieve the oil
pressure.
Figure 3.16 Control Ring Hydraulic Hose Connections
WARNING
The SP Transport unit MUST operate as
indicated on the control panel decal. The
auger MUST move in the direction that the
handle is moved.
SERIOUS OPERATOR INJURY could occur
if the transport unit and hydraulic hoses are
not assembled correctly. If necessary,
disconnect the hoses and re-assemble.
NOTICE
Do not over-tighten!
Over-tightening hose fittings can crack the fitting or motor
body and cause the fittings to leak, and will void the motor
warranty.