Engine safety, Tire safety, Safety decals – Wheatheart Self-Propelled Auger Kit (Wheatheart R Series) User Manual
Page 13: Decal installation, Engine safety 2.9. tire safety 2.10. safety decals, Warning, Ecal, Nstallation
![background image](/manuals/598598/13/background.png)
W
HEATHEART
- S
ELF
-P
ROPELLED
A
UGER
K
IT
2. S
AFETY
F
IRST
W
HEATHEART
BH & R S
ERIES
2.8. E
NGINE
S
AFETY
30761 R0
13
• Before moving a hydraulic cylinder, ensure that the attached component is
safely secured.
2.8. ENGINE SAFETY
• Be sure to stop engine and remove key or lock out power before inspecting or
servicing engine
• Refer to engine operation manual for further details.
2.9. TIRE SAFETY
• Failure to follow proper procedures when mounting a tire on a wheel or rim
can produce an explosion that may result in serious injury or death.
• Do not attempt to mount a tire unless you have the proper equipment and
experience to do the job.
• Have a qualified tire dealer or repair service perform required tire mainte-
nance.
• When replacing worn tires, make sure they meet the original tire specifica-
tions. Never undersize the replacement tire.
• Do not weld to the tire rim with the tire mounted on the rim. This action may
cause an explosion which could result in serious injury or death.
• Inflate tires to the manufacturers's recommended pressure.
2.10. SAFETY DECALS
• Keep safety decals clean and legible at all times.
• Replace safety decals that are missing or have become illegible. See decal
location figures that follow.
• Replaced parts must display the same decal(s) as the original part.
• Safety decals are available from your distributor, dealer, or factory.
2.10.1. D
ECAL
I
NSTALLATION
1. Decal area must be clean and dry, with a temperature above 50°F (10°C).
WARNING
Hydraulic fluid can cause serious injury if it
penetrates the skin. If it does, see a doctor
immediately.
• Relieve pressure before disconnecting
hydraulic line.
• Wear proper hand and eye protection and
use wood or cardboard, not hands, when
searching for leaks.