Wheatheart Self-Propelled Auger Kit (Wheatheart R Series) - Manual (Page 11)

W HEATHEART - S ELF -P ROPELLED A UGER K IT 2. S AFETY F IRST
W HEATHEART BH & R S ERIES 2.4. T RANSPORT & P LACEMENT S AFETY
30761 R0 11
2.4. TRANSPORT & PLACEMENT SAFETY
• Before raising/lowering/mov-
ing the auger, make sure the
area around the auger is clear
of obstructions and/or unau-
thorized personnel. Never
allow anyone to stand on or
beneath auger while transport-
ing or placing auger.
• Wheels must be free to move
when raising or lowering
auger.
• Do not stand between towing
vehicle and grain auger when
hitching.
• Make certain that the hitch pin
is in place and the safety chain
is properly attached. Use a
type of hitch pin that will not
permit auger to separate from
towing vehicle.
• Use extreme care and mini-
mum ground speed when
operating or transporting on
hillsides, over rough ground,
or near ditches or fences.
• Always attach an SMV (slow moving vehicle) sign before transporting auger,
and equip the auger with the necessary lights for transportation where
required by law. Always use hazard warning flashers on the tractor/towing
vehicle when transporting unless prohibited by law.
• Do not allow riders on the machine, towing vehicle, tractor, or skid steer dur-
ing transport.
• Stay away from overhead obstructions and power lines when operating and
transporting. Electrocution can occur without direct contact.
• Ensure that tires are inflated to the manufacturer's recommended pressure.
• Review the work safety area diagram before starting work.
• Check with local authorities regarding transport on public roads. Obey all
applicable laws and regulations.
• Always travel at a safe speed, never exceeding 15 mph (24 km/hr). Reduce
speed on rough surfaces and use caution when turning corners or meeting
traffic.
• Transport auger in full down position with slight tension on cable.
• Ensure that the wheel drive motors are disengaged before towing.
Figure 2.2 Work Safety Area