Wheatheart Self-Propelled Auger Kit (Wheatheart R Series) - Manual (Page 18)

3. A SSEMBLY W HEATHEART - S ELF -P ROPELLED A UGER K IT
3.5. O VER -C ENTER D RIVE W HEATHEART BH & R S ERIES
18 30761 R0
3.5. OVER-CENTER DRIVE
1. Once the wheel is bolted to the hub, the over-center drive assembly can be
installed.
2. Position the axle cap of the over-center drive assembly squarely on the axle
tube as shown in Figure 3.4.
3. With the pinion gear flush with the ring gear (Figure 3.6), bolt the axle cap to
the axle tube.
Figure 3.6 Over-Center Assembly Positioning
Figure 3.4
Figure 3.5