See figure 3.10 and figure 3.1, S each (see figure 3.10 for correct placement) – Wheatheart WHR 130 x 51-71ft Augers PTO User Manual
Page 24
3. A
SSEMBLY
WHEATHEART - GHR & WHR GRAIN AUGERS
3.8. T
RUSS
GRAIN AUGERS SD
24
30662 R1
6. Insert other end of truss cable through this eyebolt. Pull out all slack and
secure with 2 cable clamps.
7. Tighten eyebolts to take remaining slack out of truss cable and to maintain
the appropriate upward bow. After tension is adjusted, tighten cable clamps
on truss support brackets and upper truss anchor. Check for proper side
alignment.
Important:
Once auger is fully assembled, adjust truss cables on all units (because of initial
stretching). Cables may also require adjustment for side alignment.
Figure 3.10
This manual is related to the following products: