Wheatheart WHR 130 x 51-71ft Augers PTO - Manual (Page 11)

WHEATHEART - GHR & WHR GRAIN AUGERS 2. S AFETY F IRST
GRAIN AUGERS SD 2.6. H YDRAULIC S AFETY
30662 R1 11
2.6. HYDRAULIC SAFETY
• Wear proper hand and face protection when searching for hydraulic leaks.
Escaping fluid under pressure can penetrate the skin, causing serious injury
like gangrene. In case of accident, see a doctor immediately.
• Fluid leaks in the hydraulic lift cylinders or hoses will allow the auger to lower
inadvertently. Repair all leaks and breaks immediately. Rupture could cause
damage and/or personal injury.
• A hydraulic lift is faster than a conventional hand crank—always clear area of
personnel before raising or lowering.
• Do not disconnect hydraulic couplers when hydraulic system is pressurized.
For the correct procedure, consult this manual or your tractor manual.
• Relieve pressure before unhooking hydraulic lines.
• Inspect hydraulic fittings and hoses for damage on a daily basis. Repair if
damaged.
• Ensure that the hydraulic line(s) is (are) properly connected and secure.
• Keep hydraulic line(s) away from moving parts.
• Clean connections before connecting to equipment.
2.7. OPERATIONAL SAFETY
• Have another trained person nearby who can shut down the auger in case of
accident. Always work with a second trained person around augers.
• Do not operate with any of the safety guards removed.
• Keep body, hair, and clothing away from moving parts. Stay away from intake
during operation.
• Inspect lift cable before using auger. Replace if frayed or damaged. Make
sure it is seated properly in the cable sheaves and that cable clamps are
secure.
• Operate auger on level ground free of debris. If ground is uneven, anchor the
auger to prevent tipping or upending.
• Augers are not insulated. Keep away from electrical lines. Electrocution can
occur without direct contact.
• Support the discharge end and/or anchor the intake end before operating to
prevent upending.
• Do not use auger as a hoist.
• Empty auger before raising or lowering.
• Lower auger at completion of operation or when not in use. Auger could drop
rapidly in case of cable break or hydraulic failure (where applicable).