Wheatheart X13 Power Swing - Manual (Page 8)

1. S AFETY W HEATHEART - P OWER S WING M ANUAL
1.4. M AINTENANCE S AFETY E LECTRIC AND H YDRAULIC
8 30802 R0
1.4. MAINTENANCE SAFETY
• Shut down and lock out all power before attempting maintenance of any kind.
If applicable, disconnect PTO driveline from tractor or hydraulic hoses on
units with hydraulic drive hoppers.
• After maintenance is complete, replace and secure all safety guards and
safety devices, and if applicable, service doors and cleanout covers.
• Support auger tube before attempting maintenance on the undercarriage
assembly. Auger should be in full down position for maintenance.
• Use only genuine Wheatheart replacement parts or equivalent. Replacement
parts such as intake guards, pulley guards, PTO driveline shields, winches,
and lift cables must meet ASABE standards or serious injury may result. Use
of unauthorized parts will void warranty. If in doubt, contact Wheatheart or
your Wheatheart dealer.
• Do not modify any auger components without authorization from Wheatheart.
Modification can be dangerous and result in serious injuries.
1.5. HYDRAULIC SAFETY
• Clean connections before attaching to tractor.
• Inspect hydraulic fittings and hoses for damage on a daily basis. Repair if
damaged.
• Do not disconnect hydraulic couplers when hydraulic system is pressurized.
• Wear proper hand and face protection when searching for hydraulic leaks.
Escaping fluid under pressure can penetrate the skin, causing infection and/
or toxic reaction. In case of accident, see a doctor immediately.
• Repair all leaks and breaks in hydraulic valve or hose immediately. Rupture
could cause damage and/or personal injury.
1.6. SAFETY DECALS
• Keep safety decals clean and legible at all times.
• Replace safety decals that are missing or have become illegible. See decal
location figures that follow.
• Replaced parts must display the same decal(s) as the original part.
• Safety decals are available from your distributor, dealer, or factory.
1.6.1. D ECAL I NSTALLATION
1. Decal area must be clean and dry, with a temperature above 50°F (10°C).
2. Decide on the exact position before you remove the backing paper.
3. Align
the decal over the specified area and carefully press the small portion
with the exposed sticky backing in place.
4. Slowly peel back the remaining paper and carefully smooth the remaining
portion of the decal in place.