Wheatheart X13 Power Swing - Manual (Page 28)

5. A PPENDIX W HEATHEART - P OWER S WING M ANUAL
5.1. R EMOTE T RANSMITTER I NSTRUCTIONS E LECTRIC AND H YDRAULIC
28 30802 R0
T O R EGISTER TWO T RANSMITTERS TO A R ECEIVER :
1. Switch OFF or disconnect the power to the receiver.
2. Switch ON or reconnect the power to the receiver. This opens a 20 second
registration window in the receiver processor.
3. Immediately PRESS and HOLD the RESET button on the FIRST transmitter
(see Figure 5.2) for a minimum of 5 seconds or until the FAULT LED
illuminates.
4. The FAULT LED will stay on for 2 seconds. RELEASE the RESET button on
the FIRST transmitter during this 2 second period.
5. The FAULT LED will start to flash again. PRESS and HOLD the RESET
button on the SECOND transmitter for 5 seconds or until the SET LED
illuminates. Both transmitters should now operate the receiver.
Note: To clear all codes from transmitter, hold down the red stop button for at least 45
seconds.