ClearOne XAP 800 User Manual

Page 86

Control

~ Remote Builder

Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760

To program the Volume panel

Select an ID number for the remote from the Select Remote ID list.

Click Change Name to create a more descriptive name (limit 20

characters) for the remote which is displayed in addition to the remote

number in the Select Remote ID list. The name is also updated on the

graphic label.

From the Remote Type list, select Volume. The Control Panel graphic will

change to match your selection.

Select the button or LED you want to program from the Button/LED

Selection list. You can also select the button or LED by clicking directly on

the picture of the Volume panel.

The default numbers on the left of the Volume panel LEDs represent gain

levels in decibels. To change a level, click on the LED and then select the

level from the Gain list at the bottom of the window. You can also set the

upper and lower limits of gain on LEDs L2 and L8 and then click Auto

Scale, which automatically assigns values to LEDs L3-L7 on a distributed

scale.

Click the Active Command or Inactive Command button to set the

command for operation when the button is active or inactive.

Figure 6.5. Volume Panel selected in the Remote Builder

Each Control Panel

button can be

programmed to respond

like a momentary or latching

button.

A command can be

programmed to activate or

deactivate a particular function.

✍ ✍

If you want to program

different button assign-

ments for use in a preset,

you will need to open the Remote

Builder from the Preset

Configuration pane (see page 57)

and select Use in Preset.

✍ ✍

Up to six control panels

(or five control panels and

one IR remote) can be

connected to each of the RS-485

ports. In addition to selecting the

ID number in the software, you will

also need to use the DIP switches

on the control panel to assign the

Device ID. See Appendix C: Control

Panel for more information.

✍ ✍