Clarion SR5000 - Manual (Page 31)

32
C Chhaannnneell ##1100:: If any button from a known remote is programmed to Channel 10, all remotes will
be erased from memory and the system features will revert to the default settings. This is useful in
cases where the one of the customer's remotes is lost or stolen. This will erase any lost or stolen
remotes from the system's memory. It can also be used to start from scratch if the remote buttons
were programmed incorrectly.
You can advance from one channel to another by releasing the override switch and tapping it to
advance channels and then holding it. For example, if you want to program Channel Three after
programming Channel One, release the override switch. Press it twice and release it to advance to
Channel Three. Then press it once more and hold it. The siren will chirp three times to confirm it
is ready to receive the code from the remote.
To exit the learn routine:
One long horn honk indicates that Learn Routine has been exited.
➤ ➤ Ignition is turned off.
➤ ➤ Door is closed.
➤ Override switch is pressed too many times.
➤ ➤ More than 15 seconds elapse between steps.
Remote Configurations
The remotes can be programmed with the standard or single button arm/disarm configurations by
using the Auto Learn functions in the Remote Coding Routine.
Standard Configuration
A remote that uses the standard configuration operates similarly to many factory keyless entry
remotes. A standard configuration remote allows arming, disarming, and panic mode activation
with separate buttons. When programmed for standard configuration, the remote buttons are
assigned to the following functions:
operates Arm only
operates Disarm only
operates Channel 2 and Silent Arm/Disarm
operates Panic only