Clarion SR5000 - Manual (Page 18)

19
Door Lock Harness (H4),
Wire Connection Guide
___
___
___
Peripheral Plug-In Harness
LED, 2-Pin WHITE Plug
The LED operates at (+) 2 volt DC and plugs into the two-pin WHITE port. Make sure the LED
wires are not shorted to ground as the LED will be damaged. Multiple LED’s can be used, but they
must be wired in series. The LED fits into a 9/32-inch mounting hole. Be sure to check for clearance
prior to drilling the mounting hole.
Override Switch, 2-Pin BLUE Plug
The override switch should be accessible from the driver’s seat. It plugs into the BLUE port on the
side of the unit. Since the system features valet by using the remote, the switch can be well hidden.
Consider how the button will be used before choosing a mounting location. Check for rear clearance
before drilling a 9/32-inch hole and mounting the button.The GRAY wire in the two-pin plug may
DIA-41
IMPORTANT! The door lock outputs are low current and should not be attached
directly to any high current device; they are only to be used to activate relays
Blue (-) Unlock, (+) Lock Output
Empty
Green (-) Lock, (+) Unlock Output
H4/A
H4/B
H4/C